Kanguru QS2 Bedienungsanleitung PDF herunterladen (Seite 9)

Booting From the QS2 via eSATA

BIOS Settings:

If your computer’s Serial ATA controller supports booting, you may boot from the

Kanguru QS2.

Embedded Serial ATA Controller:

You may need to enter the BIOS setup for your motherboard to change the boot

sequence so the SATA controller is the first boot device. In most cases, if your

controller is built into your motherboard (not an add-on controller card), the BIOS

will have an option to choose the SATA controller as the initial boot device.

Please consult your motherboard manual on how to change the boot order for

your computer.

Add-on Serial ATA Controller Card:

If your SATA controller is an add-on controller card, you may try to choose the

SCSI device as the first boot device. If your system does not have this option

available, your BIOS may not allow the SATA controller to be designated as a

boot device at the BIOS level. In such cases, you may be able to boot the QS2 if

there is no bootable EIDE drive installed in the system.

Installing Windows 2000/XP onto the Kanguru QS2:

Insert the Windows 2000/XP CD into your CD-ROM drive and have your

computer boot from the CD. When the Windows installation screen appears,

press F6 to have setup install Third Party Mass Storage controllers. You will be

prompted to install the drivers that were supplied by your Serial ATA controller

manufacturer. After installing the drivers, Windows setup should detect the drive

and allow Windows to be installed. Follow the instructions onscreen to finish the

installation for Windows.

1 2 3 4 5 6 7 8 9 10 11 12

Keine Kommentare

Kanguru QS2 Bedienungsanleitung Seite 9